Flytec SensBox - Manual (Page 4)

Quick start guide SensBox
4
3. General information
The SensBox is a universally usable Sensor platform for leisure activities in a wide
and varied range. The measurements provided by this device serve as information
for the user and are intended to support him in his activity. The instrument
records his movements in 3D on a SD-card in the internationally common *.igc
format. The *.igc file is provided with a digital signature which will make visible
possible manipulations of the file.
The execution of all activities is however always carried out in one's own
responsibility. Bräuniger GmbH may never be held responsible for a possible
malfunction of the SensBox in no application whatsoever. The casing is
waterproof. Therefore the SensBox can be used for all outdoor activities.
4. Startup
The SensBox is supplied with the following components:
a. USB cable
b. USB plug-in power supply for 100 … 240 V~
c. 4 GB SD smart card ( inserted into the device )
d. carrying pouch
Before the first switch-on of the SensBox please check if all parts are present.
As the next step the built-in Lithium-accumulator should be charged once.
For this purpose please connect the USB cable with the SensBox and the plug-in
power supply. The charging process will be automatically stopped upon fully
charged battery and will last several hours according to battery status. Due to the
fact that it is a standardized USB interface, the SensBox can also be charged at
other USB charge ports.