LBL Lighting MO Surf Elec Xfmr 100w 277v/12v LED - Manual (Page 3)

2A
3
Make sure the two wings are against the sides of the housing,
and insert the housing into the 4.5” hole.
Tighten the two wing screws with a screwdriver until the
wings secure the power feed port into the hole.An electric
screwdriver will make this easier.
WING
WING SCREW
WING
Attach the flexible conduit to the end of the
transformer housing.
Connect the ground wire to a suitable ground in accordance
with local electrical codes.
Connect the black thermal protector wire to the hot power
line wire with a wire nut.
Connect the white transformer wire and the white thermal
protector wire to the neutral power line wire with a wire nut.
Replace the transformer cover and screws.
Place the transformer into the ceiling through the 4.5” hole.
THERMAL
PROTECTOR
TO POWER FEED HOUSING
TRANSFORMER
Install the Transformer
4.5” HOLE
TO ELECTRICAL BOX
3 1
4
2
1
2
3
4
5
6
2B
8
7
8
Adjust the Monorail Height
3A
STRAIN RELIEF
SET SCREW
POWER FEED WIRES
1
2
6 3
6 4
Loosen the set screws on the strain relief and pull out
the power feed wires.
Cut the end power feed wires to the desired length.
With a sharp knife cut 1" from the end of the wire web
and separate the wires 8" from each other.
Push the power feed wires through the strain reliefs
leaving at least 6” of cord in the back of the canopy for
wire connections and tighten the set screws.
Separate and strip 1/2" off the wire ends. 6 5
CANOPY