Campbell Scientific CS725 Snow Water Equivalency Sensor - Manual (Page 17)

CS725 Snow Water Equivalency Sensor
9. [.dd]
The [.dd] command is used to set the current date and time. The following
menu is activated from the [.dd] command:
Modify that date? :
[1] aaaa: 2009
[2] mm: 09
[3] jj: 16
[4] hh: 15
[5] mm: 01
[6] ss: 54
[0] Exit
[99] Accept selection
To Modify: [parameter number, space, new value,CR]
The current values at the time the .dd command was entered are displayed.
To change a value, enter the parameter number followed by the new value
and then the enter key. To change the minute to 02 from 01, one would
enter the following:
5<Space>02<Enter>
After new values are entered, the long format of the date/time will be
displayed once the 99 is entered to accept the selection.
99<enter>
and the CS725 will print
16/09/2009
15:02:54
The time should be set for the purpose of control and analysis of the data.
It can be local time, GMT, or any other. The CS725 does not perform any
time zone or Daylight-Savings time correction.
The time can also be updated using the long command line format of the
date/time as follows:
.dd dd/mm/yy hh:mm:ss<enter>
or
.dd<space>dd/mm/yyyy<space>hh:mm:ss<enter>
Exampe:
.dd 05/11/2010 10:46:00<enter>
or
.dd<space>05/11/2010<space>10:46:00<enter>
Use a .d command to confirm the time has been set.
9