Campbell Scientific CS725 Snow Water Equivalency Sensor - Manual (Page 7)

Cautions / Safety Notes
• If you are unable to determine that your structure or mounting method is
suitable for the CS725 sensor, please contact an expert or professional who
can assist you in determining the structural mounting requirements for
your installation of the CS725.
• Always ensure that the collimator is secured to the structure with the long
safety cable.
• Do not disassemble the CS725 without consulting the factory first. The
CS725 contains a fine bead-like insulation material called Aerogel
Nanogel. The material is manufactured by Cabot Corporation. Proper
MSDS sheets and instructions should be obtained prior to opening the
CS725.
• The collimator is heavy and proper handling procedures need to be
followed when handling the part.
• Never force the connector on to the CS725. If the connector does not
easily fit into place then it is likely misaligned.
Abbreviations/Syntax
K The Element Potassium
SWE Snow Water Equivalency
Tl The Element Thallium
[] Square brackets identify a typed command. The content inside the
brackets is what is sent or typed and the brackets are excluded.
<> Denotes a special key for example <Enter> represents the Enter Key.