0 quick start instructions – Campbell Scientific Morningstar SunSaver-10 10A 12V Regulator User Manual
Page 5
5
requirements of the National Electrical Code Article 501-4(b)
and/or Canadian Electrical Code Article 18-156 when installing a
SunSaver in a Hazardous (Classified) Location.
W
ARNING
: Do not disconnect while the circuit is alive
unless the area is known to be nonhazardous.
A
VERTISSEMENT
: Risque D’explosion—Avant De
Deconnecter L equipment; Couper Le
Courant Ou S’assurer Que L’emplacement
Est Designe Non Gereux.
3.0 QUICK START INSTRUCTIONS
This section provides a brief overview of how to get started
using the SunSaver controller. However, please review the
entire manual to ensure best performance and years of trouble-
free service.
1. Mount the SunSaver to a vertical surface. Allow space above
and below the controller for air flow.
2. Make sure the PV and load currents will not exceed the
ratings of the SunSaver model being installed.
3. The 6 system connections to the SunSaver terminals
are numbered on the label. It is recommended that the
connections be made in order from 1 to 6.
4. Connect the BATTERY first. Use care that bare wires do not
touch the metal case of the controller.
+
–
BATTERY
SOLAR
LOAD
4
+
–
+
–
3
2
1
6
5
{
P H O T O V O L T A I C C O N T R O L L E R
12 Volts
6.5A Solar
6.0A Load
LOAD
DISCONNECT
CHARGING
Remove
Jumper
Wire for
Flooded
Battery
TEMP. SENSE
MORNINGSTAR
SEALED
OR
FLOODED
SELECT
3
1
UP
2
4
6
7
8
5
BATTERY