Campbell Scientific PakBus Networking Guide - Manual (Page 14)

PakBus Networking Guide
4.1 CRBasic Dataloggers (CR800, CR850, CR1000, and CR3000)
PakBus settings for these dataloggers are entered with the Device
Configuration Utility, which is used to administer configurable Campbell
Scientific devices.
Once connected to the datalogger with the Device Configuration Utility, the
PakBus address of the datalogger can be set. Keep in mind that each PakBus
device in the network must have a unique address.
Other PakBus related settings are activated under the Port Settings tab. Select
the appropriate communication port and enter the baud rate, beacon interval
and verify interval. To create an allowed neighbor list, choose a range of
addresses that this device will consider a neighbor on this port and click on the
Add Range button. If the allowed neighbor list is activated, the device will
ignore other devices in the network that have an address less than 4000 and are
outside the range specified in the list.
10