Campbell Scientific PakBus Networking Guide - Manual (Page 16)

PakBus Networking Guide
Once connected to the datalogger with the Device Configuration Utility, the
PakBus address of the datalogger can be set on the Deployment tab. Other
radio settings can be changed on this screen, but there are no other PakBus
settings that can be changed using Device Configuration Utility.
4.3 Edlog Dataloggers (CR510-PB, CR10X-PB and CR23X-PB)
A PakBus operating system is available for the CR510, CR10X and CR23X
dataloggers. The operating system can be sent to the datalogger with the
Device Configuration Utility.
4.3.1 PakBus Settings
PakBus settings can be entered in the datalogger using the Device
Configuration Utility. Alternatively, the user can enter PakBus settings in the
datalogger program using the Options | PakBus Settings menu item in Edlog.
Sending the program to the datalogger will configure those PakBus settings
and override any settings already in the datalogger but the preferred method of
entering PakBus settings is with the Device Configuration Utility.
In addition, PakBus settings can be manually configured or viewed in the
CR510-PB, CR10X-PB or CR23X-PB datalogger with a keyboard display.
Use *D15 and *D18 for configuration and *D17 and *D19 to view the routing
table of the datalogger.
12