Campbell Scientific PakBus Networking Guide - Manual (Page 17)

PakBus Networking Guide
Since the preferred method of entering PakBus settings is with Device
Configuration Utility, the next section describes some of the settings and
choices available for these dataloggers.
Open the Device Configuration Utility software and connect to the datalogger.
Once a connection is established, the PakBus settings for the datalogger can be
adjusted.
Under the Deployment tab of the Device Configuration Utility, enter the
PakBus address of the device in the space specified in Device Configuration
Utility. Each PakBus device in the network must have a unique address.
Allowed neighbor lists can be activated by selecting the communication port,
entering a Verify Interval, and choosing a range of addresses that this device
will consider a neighbor. If the allowed neighbor list is activated, the device
will ignore other devices in the network that have an address less than 4000
and are outside the range specified in the list.
There are no other PakBus settings to adjust with the Device Configuration
Utility for these dataloggers.
13