Campbell Scientific PC208 Datalogger Support Software - Manual (Page 3)

CR10X USERS!
The following steps explain how to convert a CR10 program to a CR10X program. This will allow you to
use the CR10X specific options and instructions within the program. You only need to do this once for
each existing program. New programs will use the CR10X templates when you select the CR10X
datalogger type.
1. Using the new EDLOG, load the existing CR10 program. Notice the datalogger caption, in the top
right portion of the screen, reads “CR10".
2. Locate the text “;{CR10}“ on the first line of the file.
3. Edit the text so it reads “;{CR10X}”.
4. Save (or Save As) the file and then close it. Do not compile the program.
5. Load the file you just saved. Notice that the datalogger caption, in the top right corner of the screen,
now reads “CR10X”.
The saving, closing, and loading of the file is critical as it changes the associated template from the
CR10 template to the CR10X template. Please do not skip any steps.
If the CR10 program was created with a version of EDLOG less then 6.0, you will need to use the
DOC2CSI utility before doing the steps given above. The PC208 manual Section 9 gives more
information on using DOC2CSI.
Thank You.