Attributions – Campbell Scientific SDM-CAN Datalogger to CANbus Interface User Manual
Page 52
SDM-CAN Datalogger-to-CANbus Interface
44
For downloading software you will need the following:
• Device Configuration Utility (DevConfig), which is bundled with
PC400 and LoggerNet datalogger support software. It is also
available at no charge from
• A copy of the SDM-CAN operating system (copied to your hard-disk)
• A PC running Microsoft Windows
• A null-modem cable that connects the RS-232 port on the SDM-CAN
to a serial port on your PC
The SDM-CAN also requires a 12V power supply, but does not have to be
connected to a datalogger.
To load the new operating system take the following steps:
• Run DevConfig and select SDM-CAN for the device type.
• Follow the instructions presented in DevConfig.
• Wait until the process has completely finished and reports a successful
upgrade before removing power from the SDM-CAN or quitting
DevConfig.
6. Attributions
Microsoft and Windows are either registered trademarks or trademarks of
Microsoft Corporation in the United States and/or other countries.
Primary content of this manual is used by permission and is consistent with the
publication SDM-CAN CAN-Bus Interface User Guide, Issued 26.6.07.
Adaptations of technical content are indicted by shading.