AT&T 2325/2365 - Manual (Page 61)

ANSWERING SYSTEM
PROBLEM SOLUTION
If the system does not • Make sure that the answering system
answer after the correct is on.
number of rings:
• If Toll Saver is on, the number of rings
changes to two when you have new
messages waiting.
• In some cases, the system may be
affected by the ringing system used by
the local telephone company.
• If the memory is full or the system is off,
the system answers after 10 rings.
PROBLEM SOLUTION
If CL appears in the You need to reset the clock. See “Change
Message Window: the Clock” in the ANSWERING SYSTEM
OPERATION section of this manual.
PROBLEM SOLUTION
If the system does not • Make sure you are calling from a touch
respond to commands tone phone. When you dial a number,
from a remote touch you should hear tones. If you hear clicks
tone phone: instead, the phone is not a touch tone
telephone.
• The answering system may not detect
the Remote Access Code while your
announcement is playing. Try waiting
until the announcement is over before
entering the code.
• Make sure you enter your Remote Access
Code correctly.
• There may be noise or interference on
the phone line you are using. Press
keys firmly.
58
IN CASE OF DIFFICUL
TY
IN CASE OF DIFFICUL
TY