Alpine F1 STATUS PXI-H990 - Manual (Page 55)

51
- EN
TITLE
Performing time
correction manually
(Time Correction)
Equalizer adjust-
ments
Crossover
adjustment/
Switching the phase
MX settings
Description
Time correction cannot be performed for speakers set to
“OFF” at the speaker settings (page 7).
In reality the time difference depends not only on the
difference in physical distance but also on the delay time
between the time at which the signals are input to the
speakers until the sound is output. This delay time depends
on the speaker, and may also be somewhat affected on how
the speaker is mounted on the vehicle. After making the
setting, we recommend listening to the sound and fine-
adjusting if necessary.
After making the settings, we recommend storing them in
the memory. See page 93 for instructions.
The operations performed with the remote control unit in
step 5 can also be performed by pressing and holding
MENU (SETUP) for at least 3 seconds, moving the joystick
up or down to select “AP SETUP”, then pressing the joystick.
The equalizer adjustments cannot be made for speakers set
to “OFF” at the speaker settings (page 7).
After making the settings, we recommend storing them in
the memory. See page 93 for instructions.
The operations performed with the remote control unit in
step 2 can also be performed by pressing and holding
MENU (SETUP) for at least 3 seconds, moving the joystick
up or down to select “AP SETUP”, then pressing the joystick.
When playing back 96kHz or 192kHz DVD-Audio using the
graphic EQ, the audio signal is automatically down sampled
to 48kHz and played back.
The crossover network adjustments cannot be made for
speakers set to “OFF” at the speaker settings (page 7).
The operations performed with the remote control unit in
step 1 can also be performed by pressing and holding
MENU (SETUP) for at least 3 seconds, moving the joystick
up or down to select “AP SETUP”, then pressing the joystick.
After making the settings, we recommend storing them in
the memory. See page 93 for instructions.
The DVD Audio MX setting remains at “OFF”.
The operations performed with the remote control unit in
step 2 can also be performed by pressing and holding
MENU (SETUP) for at least 3 seconds, moving the joystick
up or down to select “AP SETUP”, then pressing the joystick.
After making the settings, we recommend storing them in
the memory. See page 93 for instructions.
When playing back 96kHz or 192kHz DVD-Audio with MX is
ON, the audio signal is automatically down sampled to
48kHz and played back.
Related page
Supplementary
information
This page includes supplementary information for pages 26 to 50.
Please refer to these pages.
Page 26
Page 26
Page 28
Page 32
Page 42
Page 42
Page 33
Page 47
Page 47
Page 32
Page 26
Page 48
Page 47
Page 34
Page 42