Samsung HPP5091X-XAA - Manual (Page 31)

1
Remove the screws on the rear of the PDP panel.
2 Connect insulation holders to screws (see the illustration below).
• If you are uncertain about installation, hire an Installation Specialist to install the
wall mount bracket.
• Be sure to check that the insulation holders are completely secured on both the left
and right side after hanging the PDP on the wall mount bracket.
• Be careful to avoid getting your fingers caught during installation.
• Make sure the wall attachment panels are tightened. Otherwise the PDP may fall.
3 Tighten the screws of the Insulation holders to the back of the PDP.
Note
• A 5 inch(12.7 cm) gap is needed between the back of the Plasma TV and the wall.
4 Put the 4 insulation holders on the PDP in the grooves of the wall mount bracket and
pull down on the PDP (Œ) to secure it to the wall mount bracket. (´) Tighten the
screws as shown (ˇ) so that the PDP cannot be separated from wall mount bracket.
Fixing the PDP panel to the wall attachment panel bracket
PDP panel
Wall attachment panel bracket Wall
Œ
´
ˇ
31