Samsung HPP5091X-XAA - Manual (Page 32)

32
1. Contact an authorized technician when installing the wall attachment panel.
2. After hanging the PDP panel on the wall attachment panel, make sure that the Insulation
holders are secure.
3. Be careful not to get your fingers caught during installation.
4. Make sure the wall attachment panel brackets are tightened. Otherwise, the PDP panel may
fall down.
5. Please secure the mounting bracket on the wall surface after setting its angle at 0°.
How to Adjust Mounting Angle
Note Note : Please secure the mounting bracket on the wall surface after setting its angle at 0°
Factory default How to Adjust Mounting Angle
The wall mount bracket is sold separately.
Please tighten the captive screw in the direction
of the arrow after assembling the bracket. Hold onto the middle of the PDP to adjust
the angle (not the sides of the PDP).
1 Secure the PDP to the wall mount bracket.
(Please refer to the following instructions.)
2 Set the angle by pulling the upper end of the PDP attached to bracket in
the direction of the arrow.
3 The angle can be adjusted from 0° to 15° by ±2°.
Change Angle
! Hold the top side of the Set and pull it to the front.
@ Before connecting cables, hold the bottom side of the Set and pull it to the front.
# After connecting cables, push the bottom side of the Set back in.
$ Push the topside of the Set back in.
% Adjust the angle of the Set by holding the top side of the Set. (Caution : Be careful not to hit the Receiver on top of
the PDP Set against the wall when you connect the cables. Follow the order indicated in the provided diagram above
for cable connections.)
Connecting External Devices to the PDP
Pull
Pull
! @
Push
#
Push
$ %