Alto-Shaam Combitherm 4.10ESi - Manual (Page 10)

CT ExpRESS INSTALLATION MANUAL • 8 .
water requirements water quality minimum standards
ONE (1) COLD WATER INLETS - DRINKING QUALITY
ONE (1) WATER INLET: 3/4" g*
LINE PRESSURE: 30 to 90 psi
2.8 to 6.2 bar
WATER DRAIN: 1-1/2" connecTion wiTh a 2" MiniMuM air gap
insTalled as close To The oVen as possiBle
using a waTer supply noT MeeTing alTo-shaaM’s MiniMuM
waTer QualiTy sTandards will Void This warranTy.
it is the responsibility of the purchaser to ensure that incoming water supply is
compliant with the specifi cations listed through adequate treatment measures.
installation of the combiguard
TM water Filtration system is recommended, but
this system may not address all water quality issues present.
clearance requirements Contaminant
Free chlorine
hardness
chloride
ph
alkalinity
silica
Total dissolved solids (tds)
Inlet Water Requirements ( untreated water )
less than 0.1 ppm (mg/l)
less than 3 gpg (52 ppm)
less than 30 ppm (mg/l)
7.0 to 8.5
less than 50 ppm (mg/l)
less than 12 ppm (mg/l)
less than 60 ppm
LEFT: 4" (152mm) RECOMMENDED SERVICE access: 18" (457mm)
20" (508mm) FROM HEAT PRODUCING EQUIPMENT
RIGHT: 4" (102mm) TOP: 20" (508mm) For air MoVeMenT
BACK: 4" (102mm) BOTTOM: 4" (102mm) For air MoVeMenT
* can add a y valve
for the optional
hand sprayer.
dimensions: h x w x d
EXTERIOR:
33-1/2" x 20-7/16" x 35-3/4" (850mm x 517mm x 906mm)
EXTERIOR WITH OPTIONAL HAND SPRAYER:
33-1/2" x 23-7/16" x 35-3/4" (850mm x 593mm x 906mm)
4•10
es
i
installation requirements
• oven must be installed level.
• Hood installation is required.
• Water supply shut off valve and back flow preventer when
required by local code.
weight capacity
neT 180 lbs (82 kg) Full-siZe pans: 20" x 12" x 2-1/2" Four (4)
ship 310 lbs (141 kg) gn 1/1: 530 x 325 x 65mm Four (4)
craTe diMensions: (l x w x h)
37" x 42" x 45"
(940mm x 1067mm x 1143mm)
halF-siZe sheeT pans: 18" x 13" x 1" eight (8)
gn 1/2: 265 x 325 x 65mm eight (8)
48 lb (22 kg) MaXiMuM
VoluMe MaXiMuM: 30 quarts (38 liters)
electrical (DEDICATED CIRCUIT REQUIRED)
Model VolTage ph hZ aMps kw awg cord & plug
4•10 ES i 208 1 60 22.5 4.68 — NEMA L6-30P - US
ONLY
208 – 240 3 60 15.0 – 18.0 5.4 – 7.48 10 NO CORD OR PLUG
380 – 415 3 50/60 9.0 – 10.0 6.0 – 7.18 10 NO CORD OR PLUG
2"
(50mm) 4-5/16
" (109mm)
7-1/4
" (182mm)
10-15/16
" (278mm)
16-15/16
" (430mm)
EXHAUST VENT
A=WATER INLET
B=DRAIN
C=ELECTRICAL
Cord Length
120V - 8 ft. (2438mm)
35-3/4
" (906mm)
35-3/4" (906mm)
20-13/16"
(527mm)
39-1/2" (1003mm)
20-7/16"
(517mm)
17-7/16"
(442mm)
23-7/16" (593mm)
33-1/2
" (850mm)
27-1/2
" (697mm)
4"
(102mm)
52-3/16
" (1325mm)
A B C
RH DOOR LH DOOR