ATEN Altusen KVM on the Net KN2108 - Manual (Page 27)

Single Station Installation
In a Single Stage installation, there are no additional KVM switches
cascaded down from the KN2108 / KN2116. To set up a single stage
installation, refer to the installation diagrams starting on p. 16 (the numbers
in the diagram correspond with the numbers of the instruction steps), and do
the following:
1. Plug your Local Console’s keyboard, mouse, and monitor into the unit’s
Console Ports.
Note: The distance between the console and the KN2108 / KN2116 must
not exceed 20m.
2. Use Cat. 5 cable to connect any available KVM port to a KVM adapter
cable that is appropriate for the computer you are installing (see the table
on p. 5 for details).
Note: The distance between the KN2108 / KN2116 and the KVM
adapter cable must not exceed 20m.
3. Connect the KVM adapter cable to the computer.
Plug the connectors on the KVM adapter cable into the appropriate ports
of the computer you are installing.
4. Plug the cable from the LAN or WAN into the KN2108 / KN2116’s
RJ-45 socket.
5. Plug the female end of the power cord into the KN2108 / KN2116’s
Power Socket; plug the male end into an AC power source.
6. Turn on the power to the KN2108 / KN2116.
After the KN2108 / KN2116 is powered up, you can turn on the computers.
2005-08-24
Chapter 2. Hardware Setup
15