Aiphone FK1629 B 0811YZ - Manual (Page 20)

20
Registering stations
[System setting – Registering stations]
Register all the stations connected in the system, and set the
area, station no. and station name to them.
Click 1 Registering stations in the table of contents.
Set the area, station no. and station name to the 2
target stations.
Setting the station no. is required to register the *
station to the system.
For a cell with the * mark, select the target one from the
pull-down menu.
Do not set stations with the same number in an area. *
NOTE:
The name of a master station displayed on its monitor in standby
mode is up to 16 alphanumeric characters.
Other buttons
Connection check •
Click to confi rm the connected units.
Connected: yellowish green
Not connected: gray
Station type error: pink
[Collective setting]: •
The following buttons are used to make the settings to all
the checked stations at one time.
Pressing each button opens another window. *
NOTE:
Be sure to check all the target stations before using these
buttons.
Area •
Click to set the same area number to all the checked
stations.
Station number •
Click to assign sequential numbers to all the checked
stations from top to bottom. The number you enter will
be set as the fi rst number and will be assigned to the top
station of the ones checked. Other checked stations will
be numbered sequentially.
Station name •
Click to assign the same station name and sequential
numbers to all the checked stations from the top down.
Enter a name only.
Station type •
(Not available in a network direct system.)
How to select multiple stations
○ Click to check the stations you will register.
○ By clicking the button on the top of the list, you can
check or cancel all the stations on the list.
Click 3 Temporarily stored to save the current setting
results temporarily.
If you wish to cancel the setting results you have made, *
click a title in the table of contents or “Refresh” in the
web browser menu.