Allied Telesis x510 Series - Manual (Page 89)

89
Chapter 7
Powering On the Stack
This chapter contains the following procedures:
 “Powering On the Switches Individually” on page 90
 “Powering On the Switches Simultaneously” on page 93
 “Verifying the Stack” on page 95
 “Monitoring the Initialization Processes” on page 98
Perform “Powering On the Switches Individually” on page 90 if you want to
control the assignment of the ID numbers to the switches of the stack. The
numbers are assigned in the order in which you power on the units.
Otherwise, perform “Powering On the Switches Simultaneously” on
page 93 to have the switches assign the numbers automatically. After the
ID numbers are assigned, you may change them with the STACK
RENUMBER command, described in the Software Reference for x510
Series Switches, AlliedWare Plus Operating System.
Caution
You should not change the ID numbers of the switches after you
begin to configure the parameter settings. Otherwise, the stack
might assign configuration settings to the wrong units.