Allied Telesis AT-2972T/2 - Manual (Page 101)

AT-29xx Series Gigabit Ethernet Network Adapters Installation Guide
101
Using Keywords for the B57.dos Drivers
The Protocol.ini file contains certain keywords that are used by the
B57.dos drivers. These keywords are listed below:
BusNum. Specifies the PCI bus number on which the network controller is
located. Requires a decimal number having a value ranging from 0 to 255.
DevNum. Specifies the device number assigned to the network controller
when it is configured by the PCI BIOS. Requires a decimal number having
a value ranging from 0 to 255.
FuncNum or PortNum. Specifies the PCI function or port number
assigned to the network controller. Requires a decimal number having a
value ranging from 0 to 7.
Note
The BusNum, DevNum, and FuncNum (or PortNum) keywords are
needed when multiple controllers are installed in the computer and
when a specific controller must be loaded in a certain order. These
keywords are used concurrently and are included for manufacturing
purposes. Do not use them unless you are familiar with how to
configure PCI devices. A PCI device scan utility is needed to find this
information.
NodeAddress. Specifies the network address used by the network
controller. If a multicast address or a broadcast address is specified, the
controller uses the default MAC address.
Example
[B57]
DriverName = "B57$"
BusNum = 3
DevNum = 14
PortNum = 2
LineSpeed = 1000
Fuplex = Full
NodeAddress = 001020304050