Allied Telesis AT-2972T/2 - Manual (Page 118)

Chapter 11: DOS Diagnostics
118
Introduction
This chapter describes how to use the DOS diagnostic utilities program on
an Allied Telesis AT-29xx Series Gigabit Ethernet Network adapter. As a
prerequisite, the AT-29xx DOS Diagnostics requires a bootable DOS
partition.
You can enter a command from the DOS prompt or the command line
interface (CLI) prompt. Otherwise, the parameter is used as an executable
command and then exits the program.
For the latest DOS diagnostics and User Guide, visit the
www.alliedtelesis.com/support/software website.