Allied Telesis AT-2972T/2 - Manual (Page 96)

Chapter 8: Installing the NDIS2 Driver Software for MS-DOS Platforms
96
Installing the NDIS2 Driver Software for Use on MS-DOS Platforms
You can run the NDIS2 driver software from an MS-DOS startup disk
using Microsoft Network Client 3.0.
Pre-Installation
Requirements
Before you can successfully install the NDIS2 driver software, the
Allied Telesis AT-29xx Series Gigabit Ethernet Network adapter must be
physically installed in the computer.
Modifying the
Startup Disk
To modify the startup disk, perform the following procedure:
1. Edit A:\Net\Protocol.ini with Notepad or a similar text editor.
a. Change DriverName=$ to DriverName=B57$.
b. Remove all other parameter entries under the [MS$NE2CLONE] or
equivalent section such as IOBASE=0x300 or INTERRUPT=3, and
so on.
Example Protocol.ini for IP
[network.setup]
version=0x3110
netcard=ms$ne2clone,1,MS$NE2CLONE,1
transport=tcpip,TCPIP
lana0=ms$ne2clone,1,tcpip
[MS$NE2CLONE]
DriverName=B57$
[protman]
DriverName=PROTMAN$
PRIORITY=MS$NDISHLP
[tcpip]
NBSessions=6
DefaultGateway=0 ; SubNetMask=255 0 0 0
; IPAddress=192 168 0 1
DisableDHCP=0
DriverName=TCPIP$