Allied Telesis AT-GS950/8POE - Manual (Page 39)

AT-GS950/8POE Gigabit Ethernet WebSmart Switch Installation Guide
39
Installing the Switch in an Equipment Rack
To install the switch in a standard 19-inch rack, perform the following
procedure:
Note
Steps 1, 2, and 3 are optional. These steps provide instructions on
how to remove the snap-on plastic feet from the bottom of a switch.
You can leave the feet attached to the switch.
1. Place the switch upside down on a level, secure surface.
2. Using a flat-head screwdriver, remove the snap-on plastic feet from the
bottom of the switch, as shown in Figure 7.
Figure 7. Removing the Feet
3. Turn the switch over.
4. Attach a rack-mount bracket to one side of the switch using four of the
screws that come with the switch, as shown in Figure 8 on page 40.