Allied Telesis AlliedView-UM 2.0 - Manual (Page 57)

For devices that use non-AlliedWare™ management software, a release filename must be
specified. After specifying the release file, the Available Devices list will be populated with
the IP Addresses of the device definitions that can use the specified software release file.
Device selection is performed as follows:
1. Clicking the button moves all selected/highlighted IP addresses from the
Available Devices list to the Selected Devices list.
2. Clicking the button moves all IP addresses form the Available Devices list
to the Selected Devices list.
3. Clicking the button moves all the selected/highlighted IP address from the
Selected Devices list to the Available Devices list.
4. Clicking the button moves all the IP address from the Selected Devices list
to the Available Devices list.
5. The Family combo box will be populated with the Device Family names applicable
to the release file indicated in the Release Filename field. Clicking on this combo box
and selecting a specific Device Family will limit the contents of the Available Devices
list to that of the IP addresses of the devices that belong to the selected Device
Family.
6. The Group combo box will be populated with the device groups defined under the
Device Family selected in the previous step. Clicking on the Group combo box and
selecting a specific device group will limit the contents of the Available Devices list
to that of the IP addresses of the devices that belong to the selected Group.
However, the contents of the Selected Devices list will not be affected. For instance,
suppose that Selected Devices list contains IP addresses for devices that belong to
Group “A”. Then, Group “B” has been chosen in the Device Group combo box.
The Available Devices list will now only contain the IP addresses of the devices that
belong to Group “B”. However, the Selected Devices list will remain unchanged.
7. The Model combo box will be populated with the models supported by the Device
Family or Group selected in the previous step. Clicking on the Model combo box
and selecting a specific device model will limit the contents of the Available Devices
list to that of the IP addresses of the devices that belong to the selected Model.
However, the contents of the Selected Devices list will not be affected.
AlliedView™-UM 2.0 USER’S GUIDE Page 57 of 128