Allied Telesis AT-S41 - Manual (Page 220)

AT-S41 User’s Guide
220
Adding Static MAC Addresses
The management software allows you to assign up to 256 static MAC
addresses on an AT-8326GB switch.
To add a static address to the MAC address table, perform the following
procedure:
1. Click on the Basic Config menu tab and select Forwarding DB from the
sub-menu. Choose Static FDB from the next sub-menu.
The Static MAC Address Configuration page will appear, as
displayed in Figure 78.
Figure 78 Static MAC Address Configuration
2. Enter a MAC Address you want to configure in the MAC Address field.
3. Use the Stack ID pull-down menu to select the switch whose ports
you want to configure.
4. Use the Port Number pull-down menu to select the port number you
want to configure.
5. Enter a VLAN ID value in the VLAN ID field.
6. Click the Apply button.
The management software adds the static address to the MAC
address table for the specified port and VLAN.
7. Repeat steps 2, 3, and 5 to enter additional static MAC addresses.