Spektrum SPM3200 DX3R PRO - Manual (Page 18)

17 SPEKTRUM DX3R PRO USER GUIDE
EN
GAUGES
You can select which gauges to display on the telemetry
data screen. The Batt, Temp and Speed gauges are
displayed by default. The Lap gauge can also be added.
• Rotate the roller to highlight the
box by each gauge.
• Press the roller to select (solid
box) or deselect (empty box) a
gauge.
Telemetry Sensor Settings
The DX3R PRO allows you to modify the settings for
the Speed, Temp, and Batt sensor.
Tele: Speed
Unit: Select MPH or KM/H display units.
Roll Out: The Roll Out function is the internal calculator
that can convert rpm data to mph or km/h. When the
Roll Out value is set to 1.0, the default setting, the value
displayed on the main screen and stored in maximum
speed is true rpm of the shaft gear or flywheel that the
rpm sensor is hooked up to. In order to program the
unit to display speed in mph, a conversion factor is
needed. Following are two methods of determining the
conversion factor.
Method A
• Mark the clutch bell that the sensor is reading from
with a small reference mark. A marker works well.
• Set the car next to a ruler and at 0” then roll the car
forward by hand, counting each revolution of the
reference mark. At exactly 10 revolutions stop the car.
• Measure the exact distance the car traveled in ten
revolutions and divide this distance by 10 (e.g.,
12.0” divided by 10 = 1.20”).
XXF
XXF MAX
5.2v
0
0 rpm
LAP: 0
0:00.00
Batt
Temp
Temp max
Speed
RPM
Laps
Time
RF Mode
The DX3R PRO has a France RF Mode that complies
with French regulations. The RF mode should be set
to STD (standard output) and should only be changed
to FR (France) when operating your transmitter in
France.
• In the System screen highlight RF Mode and press
the roller to access the function.
• Use the roller to change the RF Mode.
• Press the roller to set the value.
TElEmETry*
The Telemetry function is used to select a default
screen for displaying telemetry data. It is also
used to access the Telemetry SPEED, BATTERY,
TEMPERATURE, and LAP settings.
• In the List screen use the roller
to highlight Telemetry then
press the roller.
The Tel. Setup screen appears.
* Telemetry sensors, mounting
brackets, and telemetry
compatible receivers sold
separately.
Screen
The screen functions allows you to choose how the
telemetry data screen is accessed. Three options are
available:
MAIN: Only the main screen in displayed. The
telemetry data screen is hidden.
TELE: Only the telemetry data screen is
displayed. The main screen is hidden.
ROLL: The roller is used to switch between the
telemetry data and main screens.
• Rotate the roller and choose your desired default
screen.
• Press the roller to select.
Tel. Setup
01: Model 01
Screen: Main
Batt:
Temp:
Speed:
Laps:
Tele:Speed
Units: MPH
Roll: 1.00
Tel. Setup
01: Model 01
Screen: Main
Batt:
Temp:
Speed:
Laps:
Tele:Speed
Units: MPH
Roll: 1.00