PerTronix Dougs Headers D6671 - Manual

Part No. 0110-003059
Page 1
rev.1 8-23-2011 DSL
HEADER INSTALLATION INSTRUCTIONS
APPLICATION
1979-1993 FORD Mustang, 255-302W
PART NUMBER: D6671
PerTronix ©
thanks you for choosing
DOUG’S HEADERS, the best fitting, highest quality header on the market. In order to
realize the full potential of our good fit, please read and understand these instructions completely prior to starting work.
CHECK TO MAKE SURE YOU RECEIVED THE PROPER PARTS FOR YOUR APPLICATION. THE HEADER NUMBER WILL BE
STAMPED ON THE ENGINE FLANGE. IF YOU ARE UNSURE YOU HAVE RECEIVED THE PROPER PARTS CALL BEFORE
YOU START WORK.
BE SURE TO WORK SAFE! WHENEVER YOU WORK UNDER THE VEHICLE BE SURE THAT IT IS LOCATED ON LEVEL,
SOLID GROUND AND IS SUPPORTED BY ADEQUATE SAFETY STANDS!
REMEMBER: HOT ASPHALT WILL NOT SUPPORT MOST JACK STANDS!
Many factors affect the installation of headers, some of which are broken or aftermarket motor mounts, accidents that impact the
configuration of the frame, and/or the installation of different engines or aftermarket cylinder heads. Most installations require some
welding. If you are uncomfortable with welding operations, we recommend that you contact a professional exhaust system specialist
to install your new headers.
Attention Customers breaking in new engines: Due to the extreme heat generated during the break-in process, the appearance of
the ceramic coating may be altered in certain areas. The protection characteristics and thermal barrier properties of the coating is
never compromised. It is recommended that a cast iron manifold or old set of headers be used for this process.
Notice: The coating of these headers can be marred or scratched during installation. If the header needs to be returned and is
damaged, you will be charged for recoat.
Note: The installation of this header require s that you use factory “Dual Hump”
transmission crossmember, which came on ’86-’89 Mustang 5.0 Liter models.
These Headers utilize two Slip Tubes on each side. Doug’s only makes a partial cut through
the flange during manufacturing and the customer MUST Cut the Flange the rest of the way in
order to install these headers
Corporate Office: PerTronix Inc. 440 E. Arrow Highway, San Dimas, California 91773 * Phone 909.599.5955 * FAX 909.599.6424 * www.dougsheaders.com