Nikon LS-1000 - Manual (Page 29)

- 29 -
Insertion of Strip film
Insert the strip film into the attached film holder FH-2, and then
insert the holder into the film slot of the front panel of the Unit.
Step 1
Remove the adaptor snap and open the upper holder. Be sure
the word Nikon, printed on the adaptor cover of the upper
holder is facing upward.
Step 2
Place the strip film on the concave section which is fixed in the
adaptor of the lower holder. Be sure to place the strip film so
that the emulsion surface will be facing down (the shiny surface
will be facing up). The direction is correct if the image number
can be read.
Adaptor snap
Upper holder
Adaptor cover
Insertion
direction
Strip film
Aperture
Lower holder