Nikon D2Xs - Manual (Page 267)

253
Technical Notes—Caring for the Camera
Caring for the Camera
Storage and Maintenance
Storage
When the camera will not be used for an extended period, replace the mon-
i tor cover, remove the battery, and store the battery in a cool, dry area with
the terminal cover in place. To pre vent mold or mil dew, store the cam era in a
dry, well-ven ti lat ed area. Do not store your cam era with naph tha or cam phor
moth balls or in lo ca tions that:
• are poorly ventilated or damp
• are next to equipment that produces strong elec tro mag net ic fi elds, such as
televisions or radios
• are exposed to temperatures above 50 °C/122 °F (for example, near a
space heater or in a closed ve hi cle on a hot day) or below –10 °C (14 °F)
• are subject to humidities of over 60%
See “Caring for the Camera and Battery” ( iv–v) for more information.
Cleaning
Ambient
light sensor
Use a blower to remove dust and lint, then wipe gently with a soft, dry
cloth. Do not use alcohol or lens cleaning solutions.
Camera
body
Use a blower to remove dust, dirt, or sand then wipe gently with a soft, dry
cloth. After using the camera at the beach or seaside, wipe off any sand or
salt with a dry cloth lightly dampened with fresh water, then dry thoroughly.
The camera may be damaged if foreign matter gets inside the camera body.
Nikon cannot accept liability for damage caused by dirt or sand.
Lens,
mirror, and
viewfi nder
These elements are made of glass and are easily dam aged. Remove
dust and lint with a blower. If using an aerosol blower, keep the can
vertical to prevent the discharge of liquid. To remove fi ngerprints and
other stains, apply a small amount of lens cleaner to a soft cloth and
clean with care.
Monitor
Remove dust and lint with a blower. When removing fi ngerprints and
other stains, wipe the surface lightly with a soft cloth or chamois leath er.
Do not apply pressure, as this could result in damage or malfunction.
The Monitor
Should the monitor break, care should be taken to avoid injury caused by broken glass
and to prevent liquid crystal from entering your eyes and mouth.
The Control Panel
Rarely, static electricity may cause the control panel to brighten or darken. This does
not indicate a malfunction; the display will shortly return to normal.