A191), Shooting – Nikon P6000 User Manual
Page 205
191
Troubleshooting
Te
ch
n
ic
a
l N
o
te
s
Electronically Controlled Cameras
In extremely rare instances, unusual characters may appear in the monitor and the camera
may stop functioning. In most cases, this phenomenon is caused by a strong external
static charge. Turn the camera off, remove and replace the battery, then turn the camera
on again. Data that were present when the camera stops functioning may be lost as a
result of this, but existing data in the internal memory or memory card will not be lost. In
the event of continued malfunction, contact your retailer or Nikon-authorized service
representative.
Shooting
Date not
appearing on
pictures even
when Date
imprint is
enabled.
Dates cannot be imprinted in the following situations.
• When Sports, Museum or Panorama assist is selected
in scene mode
• When Image quality in the shooting menu is set to NRW
(RAW), NRW (RAW) + Fine, NRW (RAW) + Normal or
NRW (RAW) + Basic
• Continuous, BSS, or Continuous flash is selected for
Continuous.
• When modes other than Off is selected for Auto
bracketing
• Movies
Camera settings
reset.
Backup battery is exhausted; all settings were restored to
their default values.
Monitor turns off,
and the power-on
lamp blinks rapidly.
Battery temperature is high. Turn off camera, and allow
battery to cool down before resuming use. After the lamp
blinks for three minutes, the camera will turn off
automatically, but you can also press the power switch to
turn it off manually.
Problem
Cause/Solution
A
Camera does not
shoot.
• When camera is in playback mode, press the
c button or
the shutter-release button.
• When menus are displayed, press the
d button.
• Battery is low.
• Raise the built-in flash when the scene mode is set to
Night portrait or Backlight, or when Continuous is set
to Continuous flash.
• When flash lamp blinks red, flash is charging.
Problem
Cause/Solution
A