A.J. Antunes & Co VCT-1000 9210717 - Manual (Page 13)

13 P/N 1010884 Rev. c 04/12
Vertical contact toaster
A.J. Antunes & Co.
trOublesHOOtinG
warninG
to avoid possible personal injury and/or damage to the unit, inspection, test and repair of electrical equipment
should be performed by qualified service personnel. the unit should be unplugged when servicing, except when
electrical tests are required. use extreme care during electrical circuit tests. Live circuits will be exposed.
problem possible cause corrective action
No heat and conveyor
belts do not move.
toaster is installed incorrectly. Perform the procedures found in the installation
and Operation sections of this manual.
inoperable power cord or Power
switch.
check receptacle for correct voltage (see the
specifications section of this manual).
if necessary, contact your maintenance person
or authorized service agency for service.
Hi-Limit control is tripped. Reset the Hi-Limit control.
Wiring problem. contact your maintenance person or authorized
service agency for service.
No heat but conveyor
belt chains rotate.
Wiring problem. contact your maintenance person or authorized
service agency for service.
inoperative Platen.
inoperable thermostat.
Platen is hot but
conveyor belt chains do
not rotate.
Heat shield not installed. install Heat shield.
conveyor safety interlock switch not
activated by the Heat shield.
Re-install the Heat shield correctly so that the
Heat shield applies appropriate pressure on the
conveyor safety interlock switch.
spring tensioner assembly or Roller
tensioner is damaged or missing.
Replace spring tensioner or Roller tensioners if
damaged or missing.
conveyor belt chain links too loose. adjust conveyor belt chain length as described
in the Maintenance section of this manual.
inoperable Drive Motor. contact your maintenance person or authorized
service agency.
Loose Drive Motor sprocket
setscrew.
Drive Motor chain has fallen off
sprocket(s).
inoperable safety interlock switch.
conveyor belts chains
hesitate to rotate and/or
skip on sprockets.
conveyor belt chains installed
incorrectly.
install conveyor belt chains as described in the
Maintenance section of this manual.
conveyor belt chains too loose. adjust conveyor belt chain length as described
in the Maintenance section of this manual.
spring tensioner assembly or Roller
tensioner is damaged or missing.
Replace spring tensioner assembly or Roller
tensioners if damaged or missing.