A.J. Antunes & Co VCT-1000 9210727 - Manual (Page 11)

11 P/N 1010807 Rev. K 07/14
Problem Possible Cause Corrective Action
Product is over toasted, Platen
heat is too high, or drop time is
too slow.
Temperature set too high. Set temperature control to a lower setting.
Bun Thickness Compression Knobs set
improperly.
Measure bun thickness and set Bun Thickness Compression Knobs cor-
rectly (Figure 7).
Buns sticking on Release Sheet. Clean or replace Release Sheet according to the procedure in the Mainte-
nance section of this manual.
Conveyor Cover Assembly not installed
properly.
Re-install Conveyor Cover Assembly.
Loose sprocket setscrews. Check drive chain for kinks, broken or bent links, or other damage. Check
motor sprocket and drive sprockets; tighten setscrew on flat of shaft if
required. Check for damaged/worn sprocket and replace as required.
Conveyor Belt Chain too loose. Adjust Conveyor Belt Chain length as described in the Maintenance sec-
tion of this manual.
Spring Tensioner Assembly or Roller Ten-
sioner is damaged or missing.
Replace Spring Tensioner Assembly or Roller Tensioner if damaged or
missing.
Product is under toasted, Platen
heat is too low, or drop time is
too fast.
Bun Thickness Compression Knobs set
improperly.
Measure bun thickness and set Bun Thickness Compression Knobs cor-
rectly (Figure 7).
Wiring problem. Contact your maintenance person or Authorized Service Agency for
service.
Inoperable Thermostat.
Conveyor Drive Motor inoperable or incor-
rect conveyor motor installed in toaster.
Product is getting stuck or
Conveyor Belt Chains stop when
product is toasting.
Bun Thickness Compression Knobs Set
improperly.
Measure bun thickness and set Bun Thickness Compression Knobs cor-
rectly.
Release Sheet not cleaned properly or is
missing.
Clean or replace Release Sheet as described in the Maintenance section
of this manual..
Conveyor Drive motor inoperative or incor-
rect conveyor motor installed in toaster.
Contact your maintenance person or Authorized Service Agency for
service.
Conveyor Drive Chain loose, worn, or bro-
ken. Loose motor drive sprocket.
Check drive chain for kinks, broken or bent links, or other damage. Check
motor sprocket and drive sprockets, tighten setscrew on flat of shaft if
required. Check for damaged/worn sprockets and replace as required.
Conveyor Belt Chain too loose. Adjust Conveyor Belt Chain length as described in the Maintenance sec-
tion of this manual.
Spring Tensioner Assembly or Roller Ten-
sioner is damaged or missing.
Replace Spring Tensioner Assembly or Roller Tensioner if damaged or
missing.