Checking the roller tensioners (every 3–6 months) – A.J. Antunes & Co VCT-1000 9210727 User Manual

Page 9

Advertising
background image

9

P/N 1010807 Rev. K 07/14

Replacing conveyor belt Chains

1. Turn the power off, unplug the

power cord, and allow the unit to

cool before proceeding.

2. Remove the Butter Wheel, Pan, and

Heat Shield and set the Compression

Control Knobs to 6 & 6.

3. Open both Conveyor Covers and pull

the Belt Wrap Pin out of the zipper.

4. Remove & discard old Belt Wrap(s).
5. Disconnect the Conveyor Belt Chain

by squeezing any two links together

and unhooking both ends of one link

(Figure 13).

6. Place the replacement Conveyor

Belt Chain on the top sprockets with

hook ends down.

NOTE:

The ends of the hooks must point

down (Figure 13).

7. Wrap the Conveyor Belt Chain

around the top and lower sprockets

and connect by hooking both ends

together.

NOTE:

Make sure the Conveyor Belt

Chain is installed under the Up-

per Support Rod and over the

Lower Support Rod.

Figure 13. Removing Conveyor Belt Chain

ROTATION

UPPER SUPPORT ROD

LARGE LINK

P/N 0800121

SMALL LINK

P/N 0800204

Figure 12. Removing Conveyor Belt Chain

Checking the Roller Tensioners

(every 3–6 months)

Measuring The Roller Tensioners

1. Measure the Roller Tensioner on

both inner Conveyor Covers (Figure

14) using a U.S Nickel.

2. The space between the inner

Conveyor Cover and bottom of the

Tensioner wheel should be 13/16”

(2.1 cm) or the height of a U.S. Nickel.

3. Adjust or replace any damaged ones

as recommended.

Replacing the roller tensioners

1. Remove acorn nuts and old Roller

Tensioner Assembly (Figure 15).

2. Replace Tensioner Assembly, and

reassemble.

3. Make sure the spacers are placed in-

side the Tensioner arm. The spacers

are smaller than the holes to allow

the Tensioner to pivot freely.

Replacing the spring tensioner

1. Remove the acorn nuts (Figure 16).
2. Remove the old Spring Tensioner

Assembly (Figure 16).

3. Replace Tensioner Assembly and

reassemble unit.

WELD SCREWS

ACORN NUTS

SPACERS

TENSIONER

ASSY.

TAPE

Figure 15. Replacing Roller Tensioner Assy.

Figure 14. Measuring Roller Tensioner

Figure 16. Replacing Spring Tensioner Assy.

WELD SCREWS

ACORN NUTS

SPRING TEN-

SIONER ASSY.

TAPE

Advertising