A.J. Antunes & Co VCT-1000 9210727 - Manual (Page 5)

5 P/N 1010807 Rev. K 07/14
INSTALLATION
Unpacking
1. Remove unit and all packing materi-
als from shipping carton.
2. Open the large box. It should
contain:
• Bun Feeder (Figure 1)
• Bun Chute (Figure 2)
• Two Release Sheets (Figure 1)
• Authorized Service Agency Direc-
tory
• Owner’s Manual
3. Remove all packing materials and
protective coverings from the unit
and parts.
NOTE: If any parts are missing or dam-
aged, contact Antunes Technical
Service IMMEDIATELY at 1-877-
392-7854.
Assembling the Unit
NOTE: The factory has pre-installed a
Release Sheet over the Platen
(Figure 1). Verify that it is prop-
erly in place before proceeding.
1. Install the Bun Feeder (Figure 1) and
Bun Chute (Figure 2).
NOTE: Make sure Heat Shield As-
sembly is properly seated and
engages the Conveyor Interlock
Safety Switch (see Figure 1). The
conveyors will not rotate unless
the Heat Shield is in place and
correctly engages the Conveyor
Interlock Safety Switch.
NOTE: Check the Release Sheet to make
sure it is not caught in the con-
veyor. Additional Release Sheets
can be purchased through your
Authorized Service Agency under
P/N 7000249 (3-pack) or 7000250
(10-pack).
Figure 2. Installing Bun Chute
BUN CHUTE
YELLOW SUP-
PORT ROD
HOOK BUN CHUTE
OVER REAR BOTTOM
CONVEYOR COVER
YELLOW SUPPORT ROD
HEAT
SHIELD
HEAT SHIELD
CONVEYOR
COVER ASSY. (REAR)
YELLOW
SUPPORT ROD (FRONT)
CONVEYOR
COVER ASSY.
(REAR)
BUN FEEDER
CONVEYOR
COVER ASSY.
(FRONT)
RELEASE
SHEET
YELLOW SUPPORT
ROD (REAR)
BUN FEEDER
CONVEYOR
COVER ASSY.
(REAR)
SHOWN WITHOUT OPTIONAL
ROLLER TENSIONERS AND BELT
WRAPS.
SHOWN WITHOUT OPTIONAL
ROLLER TENSIONERS AND BELT
WRAPS.
REAR CON-
VEYOR BELT
CHAIN
FRONT CONVEYOR
BELT CHAIN
PLATEN
CONVEYOR INTER-
LOCK SWITCH
Figure 1. Toaster and Accessories
CAUTION
Failure to use Release Sheets may
result in damage to the unit and
loss of warranty coverage.