Vertical contact toaster, Important safety information (continued) – A.J. Antunes & Co VCT-1000 9210719 User Manual

Page 4

Advertising
background image

VERTICAL CONTACT TOASTER

4

P/N 1010930 Rev. C 09/13

In addition to the warnings and cautions in this manual,

use the following guidelines for safe operation of the

unit.

• Read all instructions before using equipment.
• For your safety, the equipment is furnished with

a properly grounded cord connector. Do NOT

attempt to defeat the grounded connector.

• Install or locate the equipment only for its intend-

ed use as described in this manual. Do NOT use

corrosive chemicals in this equipment.

• Do NOT operate this equipment if it has a dam-

aged cord or plug, if it is not working properly, or

if it has been damaged or dropped.

• This equipment should be serviced by qualified

personnel only. Contact the nearest Roundup

Authorized Service Agency for adjustment or

repair.

• Do NOT block or cover any openings on the unit.
• Do NOT immerse cord or plug in water.
• Keep cord away from heated surfaces.
• Do NOT allow cord to hang over edge of table or

counter.

The following warnings and cautions appear throughout

this manual and should be carefully observed.
• Turn the power off, unplug the power cord, and

allow unit to cool down before performing any

service or maintenance.

• The procedures in this chapter may include

the use of chemical products. These chemical

products will be highlighted with bold face let-

ters followed by the abbreviated HCS (Hazard

Communication Standard). See Hazard

Communication Standard manual for the appro-

priated Material Safety Data Sheets (MSDS).

• The toaster should be grounded according to

local electrical codes to prevent the possibility of

electrical shock. It requires a grounded recep-

tacle with separate electrical lines, protected by

fuses or circuit breaker of the proper rating.

• Bread may burn. Therefore toasters must not be

used near or below curtains or other combustible

walls and materials. Failure to maintain safe

operating distances may cause discoloration or

combustion.

• Failure to use Release Sheets may result in

damage to the equipment and loss of warranty

coverage.

• All electrical connections must be in accordance

with local electrical codes and any other appli-

cable codes.

WARNING ELECTRICAL SHOCK HAZARD.

FAILURE TO FOLLOW THESE INSTRUCTIONS

COULD RESULT IN SERIOUS INJURY OR

DEATH.

- Electrical ground is required on this appliance.

- Do NOT modify the power supply cord plug.

If it does not fit the outlet, have a proper outlet

installed by a qualified electrician.

- Do NOT use an extension cord with this

appliance.

- Check with a qualified electrician if you are

unsure if the appliance is properly grounded.

- If the power cord is damaged, it must be

replaced with a power cord available from

the manufacturer or an Authorized Service

Agency.

IMPORTANT SAFETY INFORMATION (continued)

Advertising