AccuTemp EVOLUTION ELECTRIC STEAMER - Manual (Page 14)

MP4008-0910 EVOLUTION STEAMER OWNERS MANUAL
Page 12
PREHEATING ( Fig. 11)
1) Depress the On/Off Key to turn on the steamer. The display will indicate PrE.
2) Once the steamer is preheated and ready to cook, the display will indicate COO
(Cook Mode) or HLd (Hold Mode).
3) Depress the DISP TEMP button to display the current cooking chamber
temperatu re.
COOKING ( Fig. 12)
1) Depress the COOK/HOLD button to select the Cook Mode (COO).
2) Open the door and place food into the cooking chamber. Shut the door. Cooking
begins immediately.
3) Timer — Depress the TIMER button and depress the ARROW keys [▲
or ▼] until the desired time is displayed. The timer starts
automatically. At the end of the timed cycle, a beeper will sound.
4) Depress the DISP TEMP button to display the current cooking chamber
temperature.
HOLDING (Fig. 13)
In “Hold” the steamer temperature is set for 180° F from the factory. The hold
temperature can be changed to a single value for temperatures ranging from
150° F to 190° F if required. Contact the AccuTemp Technical Service Department for
assistance at 800.480.0415 or 260.469.3040.
Hold can also be used during downtimes to save energy and water while keeping the
steamer preheated.
1) Depress the COOK/HOLD button to select the Hold Mode (HLd).
2) Open the door and place food into the cooking chamber. Shut the door.
3) Food will be held at the preset holding temperature. The factory default
setting is set at 180° F.
4)
Depress the DISP TEMP button to display the current cooking chamber
temperature.
Fig 11
Fig 12
Fig.13
Preparing the Evolution Connectionless model for use each day requires very little
time and effort. Simply verify that the steamer is clean, the drain valve is in the closed
position and the cooking chamber is filled with approximately 2½ gallons of tap water.
Close the door and push the ON/Off key on the keypad. The water level will need to be
monitored and filled as required. Do not use the low water warning lamp as the indicator
to check the water level as this can damage the steamer over time.
DAILY PREPARATION FOR USE - CONNECTIONLESS MODEL
OPERATION