AccuTemp EVOLUTION ELECTRIC STEAMER - Manual (Page 5)

MP4008-0910 EVOLUTION STEAMER OWNERS MANUAL
Page 3
BUILDING CODES and STANDARDS
The steamer must be installed in accordance with the following building codes:
International Plumbing Code 2003, ICC or Uniform Plumbing Code 2003, IAMPO.
USA: National Electric Code, ANSI/NFPA-70, state and local codes. Canada:
Canadian Electric Code, CSA C22.2 and local codes.
UNPACKING
This steamer was inspected before shipment from the factory. The shipping company
accepts full responsibility for safe delivery. Immediately after unpacking, check the steamer
for possible shipping damage. If damage is identified save the packaging material and
contact the shipping carrier immediately.
LOCATION AND PLACEMENT
To insure maximum benefit of your warranty; location, placement and leveling are critical.
The AccuTemp Evolution steamer is designed for installation on either a commercial kitchen
countertop or an AccuTemp steamer stand. Your Evolution steamer is equipped with vents
to allow the proper ventilation of air through the electrical compartments. On E6 models,
the vents are located on the bottom and rear panels. To ensure these vents work properly,
a minimum 4-inch (102 mm) clearance from these vents must be allocated. It is also
recommended that the Evolution not be placed under other wet equipment or locations.
Steam Escapes from the rear of the steamer. Condensation my occur on nearby
surfaces.
LEVELING
The steamer must be installed in a level condition. An out-of-level condition may cause
improper operation and possible damage. Damage caused by improper leveling is not
covered by warranty. Use a spirit level, resting on the top steamer cabinet surface, to
ensure it is level front-to-back and left-to-right.
COUNTER TOP INSTALLATION
Set the steamer on a hard level surface that can support the weight of the steamer. Install
the four rubber feet tips provided with your steamer onto the foot adjuster of each of the
steamer legs as shown in Fig 1. This will keep the steamer from sliding on the counter-top
under normal use. Once the rubber foot tips have been installed, rotate the foot adjusters
up or down as needed to level the steamer.
Fig 1
INSTALLATION