elektraLite PaintCan 2.0 - Manual (Page 4)

- ３ -
Installation Instructions.
a) Installing or replacing the lamp
Only install the lamp when Paintcan is unplugged from 120 volts.
The lamp must be replaced when it has reached the end of its lamp life or if it is damaged or deformed.
Before replacing the lamp let the lamp cool down. During operation, the lamp can
reach very high temperature.
During the installation of the lamp do not touch the glass bulbs with bare hands. Always use a cloth to
handle the lamps during insertion and removal. Your hands can leave a residue on the lamp which will
cause it to deform when the lamp is hot.
Do not install a lamp with a higher wattage. They generate temperatures higher than Paintcan operating
temperature and will damage the fixture both physically and electronically.
For the installation, you need one GLA or GLC 120v halogen lamp :
Procedure :
1) Unscrew the 2 screws on the back of the housing, holding the plate where the lamp is located.
2) Gently pull the socket holder using the knob in the middle.
3) Carefully insert the lamp into the socket. Please remember there is only one way to insert the lamp.
Look at the holes in the lamp socket and compare with the lamp’s pins. Gently slide the lamp and its
lamp holder back into place and fasten the 2 screws.
4) On the access plate there are 3 small screws marked A, B and C. which are used to adjust the lamp.
You can adjust the 3 screws to fine-tune the position of the lamp and get the maximum light
output.
LAMP:GLA 115V 575W
.
Do not ever operate Paintcan with the cover open. All lamps, irregardless of the manufacturer or type,
can be very volatile and can explode. Great caution must be exercised when working with these lamps
otherwise serious injury can happen.
Using different lamp manufacturers, where one has several fixtures being used together, can
result in severe differences in the colors. So beware. Also incorrect lamp adjustment can result
in both color differences and low output of the lamp.