elektraLite CP3 User Manual
Page 10
9
This will be required when using fixtures that need to have a DMX lamp strike performed on
them after powering up.
•
CUE 200 is assigned for specific re -home (reset) values.
Please refer to the CP10xt Operator’s Manual for programming procedures.
It is also possible to create chases on the CP-10xt Universal Controller that are fixture specific.
These are chases that contain cues where only one fixture changes per cue. These are usually
mirror flips, iris bursts, dimmer chases, etc.
Since the CP-3 can be configured to run less than 16 fixtures you can set up your programs to
be configured to do the same. This will allow you to create programs for up to 16 individual
fixtures but playback programs for less if needed without having “blank spots” in the programs.
To assign Fixtures to specific Cues perform the following steps:
1) On the CP-10xt press: ENTER - CUE - 996 - ENTER. The display will read:
CP3 FIXT TO CUE
CUE 001 FIXT 00
2) The cursor will be under the Cue number field. Type in the Cue number that you want to
correlate with a specific fixture.
3) Use the “+” key to move the cursor to the Fixt. Field and type in the fixture number that
correlates to the Cue.
4) Use the “+” key to toggle the cursor back to the Cue field and repeat steps 2 and 3 until
finished.