elektraLite CP3 - Manual (Page 14)

13
next. Do not connect all the fixtures up at once. Then continue on to the next fixture in the loop
until you find the problem.
DMX cabling must be wired in a single loop (serial). You cannot wire up fixtures in parallel.
Also watch out for fixtures that have ‘active’ DMX. Using the correct In and Out connectors in
these types of fixtures is imperative. If you have any doubts about wiring up a DMX loop, then
consult your supplier of the products. A conversation with him could save hours of fault finding
and replacement of cables later.
ELEKTRALITE WARRANTY
Elektralite products are warranted to be free from defects of material and workmanship for a
period of two years from the date of delivery to the original user. Repair will be made at no cost
for labor or materials within this time period. This warranty is void if the product has been
modified without prior authorization or subjected to abuse.
Before sending anything to the factory, be sure to call your Elektralite dealer/distributor for a
Return Authorization Number (RA#). Any goods shipped without an RA# will be refused at
the factory. The contents of each shipping carton from Elektralite should be carefully inspected
for signs of freight damage. If any such damage is found, you need to notify both the shipping
agent and the sales agent immediately. Any damage incurred in shipping is the responsibility of
the carrier. In the case of hidden damage, a claim should be made as soon as discovered and
all packing material retained for inspection. Freight damage claims are invalid for units shipped
in non-factory shipping materials.
Elektralite reserves the right to change product specification at any time without notice.
All warranty repairs should be returned prepaid in their original packing materials to:
©Group One Ltd.
200 Sea Lane
Farmingdale, NY 11735
U.S.A.