Configuring fixture types, Configuring the maximum number of fixtures – elektraLite CP3 User Manual
Page 4
3
CONFIGURING FIXTURE TYPES
After the fixtures are connected and the start addresses are set, you must next tell the CP-3
which type of fixture is connected. This is only necessary when running the CP-3 in
preprogrammed light show mode.
Use the DIP switches located on the rear panel of the unit to specify which fixture type you are
running. Refer to the FIXTURE DIPSWITCH CONFIGURATIONS section, on page 15 of
this manual, on how to set the DIP switches for your particular type of fixture.
In replay controller mode, it is unnecessary to touch the dip switch settings for the fixture type.
CONFIGURING THE MAXIMUM NUMBER OF FIXTURES
After the fixture type is configured you can now tell the CP-3 how many fixtures you are
running. To do so select the “Max. Fix.” Dipswitch that pertains to your particular fixture
configuration. This is only necessary when running the CP-3 in preprogrammed light show
mode.
Max. Number of Fixtures
Dipswitches set On
1
NONE
2
4
3
3
4
3 & 4
5
2
6
2 & 4
7
2 & 3
8
2, 3, & 4
9
1
10
1 & 4
11
1 & 3
12
1, 3, & 4
13
1 & 2
14
1, 2, & 4
15
1, 2, & 3
16
1, 2, 3, & 4