elektraLite MY 575w - Manual (Page 13)

-
１２ - MY575 WASH
4. Press [ENTER] to confirm.
5. Press [EXIT/DN] in order to return to the main menu.
- Software version
With this function you can display the software version of MY575.
1.
Select “VER” by pressing [UP] button.
2. Press [ENTER], the display shows “V-X.X”, “X.X“ stands for the version number, e.g. “V-1.0”,
“V-2.6”.
3. Press [ENTER] or [EXIT/DN] in order to return to the main menu.
- Main menu 3
1. Press [ENTER] for 3 seconds to enter the main menu (display flashing).
2. Press [UP] to select “ADJU”.
- Lamp adjustment
With this function you can adjust the lamp via the Display Panel. The shutter opens and the lamp can be
adjusted. In this mode, MY575 will not react to any control signal.
1.
Select “LADJ” by pressing [UP] button.
2. Press [ENTER], the display shows “ON” or “OFF”.
3. Press [UP] to select “ON” if you wish to enable this function or “OFF” if you don’t.
4. Press [ENTER] to confirm.
5. Press [EXIT/DN] in order to return to the main menu.
- Test function of each channel
With this function you can test each channel on its (correct) function.
1.
Select “tESt” by pressing [UP] button.
2. Press [ENTER], the display shows “T-XX”, “X” stands for the channel number.
3. The current channel will be tested.
4. Select the desired channel by pressing [UP] button.
5. Press [ENTER] or [EXIT/DN] to exit.