Ferguson Ariva HDplayer 210 - Manual (Page 5)

1
ENGLISH
Introduction
Product Overview
Thank you for purchasing the Ariva
HDplayer 210. This user manual provides
step-by-step instructions for installing
and using your new HD media player.
Ariva HDplayer 210 is a-compact, high-
definition (HD) (Wi-Fi Net supporting)
USB 2.0 media player that attaches to
an entertainment unit through a variety
of audio/video interfaces and supports
playback of major audio, video, and
image file formats. Player supports high-
definition video playback of up to 1080p
through an HDMI connection or standard
definition for TVs with lower capabilities.
High-fidelity digital audio is supported
from an optical interface (Toslink). Two
USB ports are available to connect USB
storage devices. The included remote
control lets you quickly browse through
your media library and configure settings.
Supplied accessories
Remote Control
two AAA batteries
HDMI cable
Safety Information
 Please observe all warnings and
instructions on the equipment and
contained in these operating instructions.
 Please carefully read this user’s manual
before using the device.
 To avoid electric-shock hazards, do not
open the cabinet, refer servicing to
qualified personnel only. If cabinet is
opened warranty will be invalid.
 Please switch off completely the device
during thunder, during abnormal
phenomenon, before cleaning it and in
case it remains out of service for a long
period.
 Do not expose the device under the
sunlight. And keep it away from the heat
source or humid environments. Do not
block ventilation holes of the device so
that air can circulate freely.
 Please place the device in horizontal and
stable conditions, keeping it away from
vibrating.
 If device is moved from warmer place to
a colder one some problem might occur.
Please switch off the device and turn it on
after 1 or 2 hours.
 Keep the device away from flower
vases, tubs, sinks, etc., in order to avoid
damaging the equipment. Do not touch
power supply with wet hands.
 Don’t put any objects on the device.
 Be sure to turn the device off and
disconnect the AC power cord before
cleaning the receiver surface. If the
surface is dirty, wipe clean with a cloth
which has been dipped in a weak soap/
and/water solution and wrung out
thoroughly, and then wipe again with a
dry cloth.
 Do not connect cables while power is
plugged.