Karcher HD 10-16-4 Cage Ex - Manual (Page 18)

– 5
 Turn the knurled nut of the detergent
nozzle in an anti-clockwise direction un-
til it stops. Detergent is suctioned with
low pressure.
– Setting the detergent concentration
 Pull the detergent suction hose out of
the detergent container.
 Turn filter on the detergent suction hose
in order to dispense the detergent.
The serial exchange nozzle is combined in
a power and a round jet nozzle.
– Here, you can switch between the pow-
er and the round jet nozzle by tilting the
spray lance slightly with the hand spray
gun closed. If necessary, if the switch-
ing does not function properly, tap light-
ly on the exchange nozzle.
– The water will emerge via the nozzle,
which has been elevated by opening
the hand spray gun.
– With the hand spray gun open, the se-
lected nozzle will always remain open,
regardless of the position of the ex-
change nozzle.
– 25° spray angle
– Carrying out the most common cleaning
tasks
– For strong contaminations
 Set the working pressure and quantity
by pulling hard on the handle on the
hand spray gun. Once the desired wa-
ter stream is reached, this handle posi-
tion can be set via the hand wheel of the
hand spray gun. Once you open it up
again, the water stream will be adjusted
automatically.
 Pull the lever on the handgun.
 Release the lever on the trigger gun.
 Turn the hand wheel on the hand spray
gun to 0 to protect the lever from being
released inadvertently.
 Store the hand spray gun and spray
pipe in the accessory mount.
 Turn the knurled nut of the detergent
nozzle in a clockwise direction until it
stops.
 Set the appliance switch to "I".
 Open the hand spray gun and rinse the
appliance for at least 1 minute.
 Release the lever on the trigger gun.
 Set the appliance switch to "0".
 Shut off water supply.
 Activate hand spray gun until device is
pressure less.
 Turn the hand wheel on the hand spray
gun to 0 to protect the lever from being
released inadvertently.
 Remove the water inlet hose from the
appliance.
 Pull out the mains plug.
 Stow away the mains cable, the high-
pressure hose and accessory at the ap-
pliance.
Caution
Risk of injury and damage! Note the weight
of the appliance in case of storage.

When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
 Release parking brake.
 Push the appliance.
Detergent dosing
Nozzle change
Power nozzle (two flat connection)
Round jet nozzle
Set working pressure and flow rate
Pressure/ quantity regulation at the
hand spray gun
Interrupting operation
After each operation
After operation with detergent
Finish operation
Transport
Driving
18 EN