Karcher KM 130-300 D - Manual (Page 24)

- 9
 Check tyre pressure.
 Drive the waste container up and se-
cure it with the safety rod.
ƽ
Danger
Risk of injury! Always apply the safety bar
when the waste container is raised.

Fold the safety rod for the high empty-
ing up and insert it into the holder (se-
cured).
1 Holder of safety rod
2 Safety rod

Open the side cover as described in
Chapter "Replace brush roller".
 Release the 6 wing nuts on the side
holding plate.
 Loosen 3 nuts (SW 13) on the front
holding plate.
 Press the side seal down (elongated
hole) until it is about 1 to 3 mm to the
floor.
 Screw in the holding plates.
 Repeat the procedure on the other side
of the appliance.
 Park the sweeper on an even surface.
 Connect air pressure testing device to
tyre valve.
 Check air pressure and adjust if re-
quired.
 For permissible tyre air pressures see
"Technical data".
 Clean the dust filter with the filter clean-
ing button.
ṇ
Warning
Empty waste container before replacing
dust filter. Wear a dust mask when working
around the dust filter. Observe safety regu-
lations on the handling of fine particulate
material.
1 Lock of appliance hood
2 Cover
 Open the lock, remove the star grip
screw to do this.
 Fold cover forwards.
 Open filter cap.
 Fold the filter vibrator forward.
 Replace the dust filter.
 Close the filter cover.
The V-Belt must deflect approx. 7-9 mm at
a pressure of 10 kg.

Get the V-belt tension adjusted by an
authorized customer service.
 Remove the air filter housing.
 Replace the air filter insert.
Note: Installation position with blowout
opening pointing down (see illustra-
tion).
 Unscrew the wing nut from the centrifu-
gal separator.
 Clean the centrifugal separator.
 Unscrew the head lamps.
 Take out the head lamps and pull out
the plug.
Note: Note the positions of the plugs.

Dismantle the head lamps.
 Dismantle the head lamp casing and
hold it horizontally because the lamp
unit is not fastened.
 Unlock the bracked and take out the
bulb.
 Insert new bulb.
 Reinstall in reverse sequence.
Adjust the side seals
Check the tyre pressure
Manually clean the dust filter
Replacing dust filter
Check and adjust the V-Belt
Check air filter and replace, if necessary
2
1
Changing the headlight bulb (option)
24 EN