Karcher KM 75-40 W Bp Pack - Manual (Page 15)

- 4
Note
The cover is unlocked with the key of the
main switch.
 Insert the key for the main switch into
the hood lock and rotate in a clockwise
direction by 90°.
 Pull the hood lock out by the key.
 Open the device hood.
 Close the appliance cover, the cover
lock will lock automatically.
ƽ DANGER
Risk of injury, risk of damage!
Observe the weight of the appliance when
you load it!
 Remove the cardboard.
 Remove the wooden blocks that secure
the wheels and raise the device from
the palette by hand.
 Release parking brake.
 Loosen the screws.
 Align the pushing handle.
 Tighten the screws.
Note: Remove the waste container and
move the pushing handle to the front prior
to tilting the appliance. Do not rest the ap-
pliance on the pushing handle.

Clip side brush on to driver and screw
on.
Please observe the following warning notes
when handling batteries:
ƽ Danger
Risk of explosion! Do not put tools or similar
on the battery, i.e. on the terminal poles
and cell connectors.
ƽ Danger
Risk of injury! Ensure that wounds never
come into contact with lead. Always clean
your hands after having worked with batter-
ies.
ƽ Danger
Risk of fire and explosion!
– Smoking and naked flames are strictly
prohibited.
– Rooms where batteries are charged
must have good ventilation because
highly explosive gas is emitted during
charging.
ƽ Danger
Danger of causticization!
– Rinse thoroughly with lots of clear water
if acid gets into the eye or comes in con-
tact with the skin.
– Then consult a doctor immediately.
– Wash off the acid If it comes in contact
with the clothes.
Note
With the KM 75/40 W Bp Pack the battery
and the charger are already built in.
 Open the device hood.
 Set the batteries on to the motor carrier.
 Secure the batteries with the holding
strap.
 Connect pole terminal (red cable) to
positive pole (+).
 Fit the connection wires to the batteries.
 Connect pole terminal to negative pole
(-).
Note: Check that the battery pole and pole
terminals are adequately protected with
pole grease.
Only use batteries with terminal cover. Re-
store terminal cover in the event of loss.
CAUTION
Charge the batteries before commissioning
the machine.
ƽ Danger
Risk of injury! The charger should be used
only if the mains cable is in an undamaged
state. Get the manufacturer, the customer
service agent or a qualified person to im-
mediately replace a damaged mains cable.
ƽ DANGER
Risk of electric shock. Observe supply net-
work and fuse protection. Only use the
charger in dry rooms with sufficient ventila-
tion.
Note: The charging time for an empty bat-
tery is approx. 12 hours.
ƽ Danger
Risk of injury! Comply with safety regula-
tions on the handling of batteries. Observe
the directions provided by the manufacturer
of the charger.
Note: Normally, the machine is equipped
with maintenance-free batteries.

Open the device hood.
 Insert the plug of the charger into the
socket.
Note: The charger has electronic controls
and automatically switches off the charging
process. All functions of the machine are
automatically interrupted during the charg-
ing process.
The battery display shows the progress of
the charging process when the plug is in-
serted:
Open the device hood.
Close device hood
Before Startup
Unloading tips
Transport weight (without
batteries) 79 kg
Weight (with batteries) 125 kg
Unloading
Installing the pushing handle
Install side brush
Batteries
Safety notes regarding the batteries
Observe the directions on the
battery, in the instructions for
use and in the vehicle operating
instructions!
Wear an eye shield!
Keep away children from acid
and batteries!
Risk of explosion!
Fire, sparks, open light, and
smoking not allowed!
Danger of causticization!
First aid!
Warning note!
Disposal!
Do not throw the battery in the
dustbin!
Installing and connecting the batteries
Charge the batteries
Charging process - KM 75/40 W Bp Pack
Batteries are being
charged glows yellow
Batteries are charged glows green
15 EN