Sony PMC-R30L - Manual (Page 22)

The Timer
22 GB
Waking up to music (continued)
Tips
• To exit the standby
mode, press STANDBY
to make the
t
indication disappear
from the display.
• The preset settings
remain until you reset
them.
Note
When you press ( or
r button of the tape
player in the timer
mode:
If the tape length of one
side is longer than the
set time, the player will
be turned off at the end
of the tape, not at the
set time.
6
Press TUNING•TIME SET + or – to set the
volume, then DSPL ENT MEM.
7
Press STANDBY.
The t indication lights up and the power goes off.
At the preset time, the power will go on, and the
music will play. Then the power will go off at the
preset time, and the player will enter the standby
mode.
To check/change when the playback will start
Press TIMER, then DSPL ENT MEM. Each time you
press DSPL ENT MEM, a stored setting is displayed in
the set order. To change the setting, display the setting
you want to change and reenter it.
To use the player before a timer playback starts
Just turn on the player, and then you can use it.
If you turn off the player before the preset time, timer
playback will start at the preset time.
In case of the radio, however, if you listen to the
station which is different from the one you tuned in
step 1 on page 21, you will hear that station at the
preset time. Make sure to tune in the station you want
to listen to before you turn off the player.
To stop play
Press OPERATE to turn off the power.