Sony TA-VE100 - Manual (Page 2)

Amplifier Operations
8 GB
Recording
This amplifier makes it easy to record to and from the
components connected to the amplifier. You don’t
have to connect playback and recording components
directly: once you select a programme source on the
amplifier, you can record and edit as you normally
would using the controls on each component.
Before you begin, make sure you’ve connected all
components properly.
ç : Audio signal flow
c : Video signal flow
Recording on a video tape
You can record from a LD player using the amplifier.
You can also add audio from a variety of audio sources
when editing a video tape.* See your VCR or LD
player’s instruction manual if you need help.
* If you connect a stereo system, or an individual audio
component, to the AUX IN jacks as shown on page 5.
1 Press VIDEO 2 (if an LD player is connected to the
VIDEO 2 jacks) to select the programme source.
2
Set the component to be ready for playing.
For example, insert the laser disc you want to
record from into the LD player.
3
Insert a blank video tape into the VCR for
recording.
4
Start recording on the VCR and then start playing
the laser disc you want to record.
You can replace audio while copying a laser disc
At the point you want to start adding different sound,
press AUX (if an audio component system is connected
to the AUX IN jacks, be sure to select the proper source
beforehand) and start playback. The sound from the
selected component will be recorded over the original
audio.
To resume recording the sound of the laser disc, press
the VIDEO 2 function button.
Playback component
(programme source)
c
з
з
c
Recording
component
(VCR)
Function buttons