Sony GDM-C520K - Manual (Page 19)

19
Op
er
at
ion
Calibrating the System----cont.
When you first start the Artisan™ Software, you will see the following screen:
1 Select the preset colorspace to which you want your display to be calibrated by clicking on the “Target Colorspace”
drop-down menu. You can calibrate your display to any one of the following standard target colorspaces:
2 Click on the desired target colorspace.
3 Click on the “Calibrate” button to continue.
Before Calibrating
❑
Make sure that your display is set to at least 16-bit color.
❑
Make sure your display is set to "Professional" mode. To do this, press the "Picture Effect" button on the front of your GDM-
C520 display until the on-screen display shows "Professional".
❑
Warm the display up by leaving the display turned on and displaying a relatively bright screen (over 50% white) for at least
an hour before calibration.
❑ Make sure that the Artisan™ Sensor is connected to one of your computer’s USB ports.
❑ Make sure that the display and sensor are clean before beginning calibration. If necessary, the suction cups can be cleaned
with a damp, lint-free cloth. The display screen should be cleaned according to the instructions titled “Notes On Cleaning
the Screen’s Surface” on page 3 of the display manual.
❑ Turn the light in the room down to approximately 16 lux. The calibration process works best when there is little light in the
room.
Name x
value
y
value
Y value
(White)
Y value
(Black)
TRC
CRS Print RGB-D50 .3457 .3587 85.0 cd/m^2 0.28 cd/m^2 Gamma 1.80
CRS Print RGB-D65 .3128 .3292 85.0 cd/m^2 0.28 cd/m^2 Gamma 1.80
CRS Web RGB (sRGB) .3128 .3292 85.0 cd/m^2 0.28 cd/m^2 Gamma 2.20
modified per ITU
initial slope