Sony DEV-5 - Manual (Page 74)


Table of C
on
ten
ts
M
enu Lists
Inde
x
GB
The image in the viewfinder is not clear .
Adjust the diopter using the right and left
diopter adjustment dial until the image
appears clearly.
Adjust the width between the right and left
viewfinder to fit your eyes (p. 15).
Use [Viewfinder Adjust] (p. 68).
Switch the viewfinder display mode to 2D by
pressing FINDER 2D/3D (p. 21).
Viewing 3D movies makes you feel
uncomfortable.
Use [Viewfinder Adjust] (p. 68).
Use [Auto 3D Lens Adjust] (p. 59).
Primary colors, such as red, blue, or green,
shimmer in the viewfinder.
You may see primary colors, red, blue, or
green, shimmering in the viewfinder when
you move your line of sight. This is not a
malfunction. The shimmering colors will not
be recorded on the memory card.
Memory card
Operations using the memory card
cannot be performed.
If you use the memory card formatted on a
computer, format it again on this product
(p. 65).
Images stored on the memory card
cannot be deleted.
The maximum number of images that you can
delete on the index screen at one time is 100.
You cannot delete the protected images.
The data file name is not indicated
correctly or flashes.
The file is damaged.
The file format is not supported by this
product (p. 87).












Recording
Refer also to “Memory card” (p. 74).
Pressing START/STOP or PHOTO does not
record images.
The playback screen is displayed. Press MODE
to turn on the (Movie) or (Photo) lamp
(p. 22).
This product is recording the image you have
just shot on the memory card. You cannot
make new recording during this period.
The memory card is full. Delete unnecessary
images (p. 34).
Total number of movie scenes or photos
exceeds the recordable capacity of this
product. Delete unnecessary images (p. 34).
The temperature of this product is extremely
high. Turn off this product and leave it for a
while in a cool place.
The temperature of this product is extremely
low. Turn off this product and take it to a
warm place. Leave this product there for a
while, then turn on this product.
Photos cannot be recorded.
You cannot record photos while recording a
movie. Press MODE to switch to the photo
mode.
When [2D/3D Mode Select] is set to [3D],
you cannot record photos. Set [2D/3D Mode
Select] to [2D].
The access lamp remains lit or flashing
even if recording was stopped.
This product is recording the scene you have
just shot on the memory card.
The imaging field looks different.
The imaging field may look different
depending on the condition of this product.
This is not a malfunction.









