Playback – Sony DEV-5 User Manual
Page 75
Table of C
on
ten
ts
M
enu Lists
Inde
x
GB
The actual recording time for movies is
less than the expected recording time of
the memory card.
Depending on the recording conditions, the
time available for recording may be shorter,
for example when recording a fast moving
object, etc.
This product stops operating.
The temperature of this product is extremely
high. Turn off this product and leave it for a
while in a cool place.
The temperature of this product is extremely
low. Turn off this product and take it to a
warm place. Leave this product there for a
while, then turn on this product.
If you keep applying vibration on this product,
recording may stop.
There is a time difference between the
point when START/STOP is pressed and
the point that the recording movie is
started or stopped actually.
On this product, there may be a slight time
difference between the point where you
press START/STOP and the actual point that
recording movie starts/stops. This is not a
malfunction.
The auto focus does not function.
Set [Focus] to [Auto] (p. 57).
The recording conditions are not suitable for
auto focus. Adjust the focus manually (p. 57).
SteadyShot does not function.
Set [
SteadyShot] to [Active] or [Standard]
(p. 60), [
SteadyShot] to [On] (p. 60).
Even if [
SteadyShot] is set to [Active] or
[Standard], [
SteadyShot] to [On], this
product may not be able to compensate for
excessive vibrations.
You may not recognize the effect when you use
the large magnification.
The subjects passing by the screen very
fast appear crooked.
This is called the focal plane phenomenon.
This is not a malfunction. Because of the way
the image device (CMOS sensor) reads out
image signals, the subjects passing by the lens
rapidly might appear crooked depending on
the recording conditions.
Horizontal stripes appear on the images.
This occurs when recording images under a
fluorescent lamp, sodium lamp, or mercury
lamp. This is not a malfunction.
Black bands appear when you record a TV
screen or computer screen.
Set [
SteadyShot] to an option except for
[Active] (p. 60).
Sound is not recorded correctly.
If you disconnect an external microphone, etc.
during recording movies, sound may not be
recorded correctly.
Connect the microphone again in the same
way as when you start recording movies.
Playback
Images cannot be played back.
Images recorded on other devices may not be
played back. This is not a malfunction.
When [2D/3D Mode Select] is set to [3D],
movies recorded with 2D cannot be played
back.